hot sale cooling tower parts pvc sheet fill cooling tower PVC fill
Cooling tower fill is one of the most important components for exchange of gas and water in cooling tower. It is the major parts to improve the efficiency of cooling tower and make sure the economy and safe operation.
Cooling tower fill is a medium utilized as a part of cooling towers to build the surface region of the tower. Expanded surface territory considers most extreme contact between the air and the water, which takes into consideration more prominent dissipation rates. The fill gives a tremendously extended air-water interface for warming of the air and vanishing to occur. The water is cooled as it slides through the fill by gravity while in immediate contact with air that disregards it. The cooled water is then gathered in a frosty water bowl beneath the fill from which it is pumped again through the procedure to assimilate more high temperature. The warmed and dampness laden air leaving the fill is released to the climate at a point remote enough from the air bays to keep its consistently stepped go into the cooling tower.
cooling tower fill fetures:
1. Greater cooling capacity in a given space
2. Low-clog designs available
3. Available in bottom supported or hanging designs
4. FM approval available
5. Crossflow and counterflow designs
6. Integral louvers and eliminators available in crossflow design.
7. High-temperature designs available
8. Single-piece, full-height counterflow designs available
Specification for Cross flow cooling tower fill as following:
| Item |
Cooling tower fill |
| Module Width |
mm |
610mm, 750mm, 813mm, 915mm, 1000mm, 1220mm, 1520mm |
| Flute Height |
mm |
19 |
| Flute Corrugation Angle |
degrees |
- |
| Surface Area |
m2/m3 |
150 |
| Sheet Thickness - Before Forming |
mm |
0.32-0.6mm |
| Max. application temp. (short time) - PVC |
°C |
60 |
| Max.operating temp. (short time) - High temp. PP |
°C |
80 |
| Customized size and thickness available for special request. Contact us for details! |
Sinta are Professional cooling tower fill manufacturer in China.
Please pay more attention to cooling tower fill when storage them.
1), Please do not expose the LC PVC fill under the strong sunshine to avoid any deformed. If the outside temperature is higher than 40 degree, the PVC film fill will be deformed within 1-2 hours under the strong sunshine. No matter it is 100% new PVC or recycle PVC, the strong sunshine will deform it very fast.
2),Please do not use the airtight or air impermeability material packing the BL PVC fill, such as the transparent plastic film or bubble plastic film. That will keep the PVC fill in a higher temperature without any cool air come in and may bring some deformed.
3),Please do not use the PVC cooling tower fill if the water temperature is more than 60 degree.
Welcome your inquiry for cooling tower fill anytime.
Jessica is always here!
Audited Supplier 
Audited Supplier 
){kind=link}
){kind=link}